Possible to connect Nand-X to 360 Clip?

[DaRkO]

Hey guys,

been trying to figure out how to/if its possible to connect a nand-x to a 360 clip.

I'm so lost trying to figure out how the MOSI,SS,SCK,MISO,GND,P0.29,P0.28 translate to the actual nand



So thats the pinout of the 360 nand and the 360 clip, any help would be appreciated!

[Martin C]

No - the NAND-x uses SPI communication via the southbridge.

The 360clip is best used with a progskeet or infectus2.

[DaRkO]

Ahk, thought as much, thanks Martin.

[WNYConsoles]

I also thought about using this with the NANDX but never got around to ordering one. It would be cool to have a solderless "clip" to read the nand on J2D1 and J2B1.

[superspeed]

I also thought about using this with the NANDX but never got around to ordering one. It would be cool to have a solderless "clip" to read the nand on J2D1 and J2B1.

You know they make solderless pin headers.

[WNYConsoles]

You know they make solderless pin headers.

Of course I know that However it is still not "solderless" like the clip is.

[DaRkO]

If TX made a nand reader compatable with the 360 clip, I would use that, but guess i'm stuck with my progskeet :P

Also, I'm only using the clip for the large volume of consoles I'm always buying and selling, If their not Jtagable or I don't RGH them, I always edit the fan speed via the nand before I sell them, too keep them cool as a cucumber :P

Still use my nand-x's daily though

[Martin C]

The progskeet is handy for erasing block 0 if someone has flashed or corrupted the SMC....

[WNYConsoles]

I always edit the fan speed via the nand before I sell them, too keep them cool as a cucumber

That is exactly what I wanted to use the clip for.