Trinity 14719 Xell not loading

[Argentum]

I made an RGH yesterday and everything was fine

I am doing an RGH now but I cannot load xell, the only difference is that I updated to new Jrunner 267

I read the nand using nandX jrunner showed they have no difference I checked it with Xnandhealer there were no bad blocks.

I have no problems with creating and writing ECC

I am glitching with coolrunner rev"B" (100% working) programmed it with jrunner after selecting 14719 dash and trinity.

Please help I hope I am not screwed

Edit:
Things I already tried: set CR to phat, rechecked and re soldered wires, reprogrammed CR, re created and rewrote ECC using JR

[BL4K3Y]

Your STBY_CLK point (orange wire) looks bridged.

Have you thought about trying the POST_OUT QSB?

You can purchase it from all Xecuter re-sellers .

[Argentum]

It might look like that from the angle the pic was taken from but it's not.

Even if it was soldered to that end of the resistor it should still work (tried it before), any way I will consider an alternative point, and I cant wait for the post QSB.

[BL4K3Y]

Here is the STBY_CLK alternate point for slim consoles.

[Argentum]

Here is the STBY_CLK alternate point for slim consoles.

Just tried that didn't work

[BL4K3Y]

I suggest you either try trimming the CPU_RST wire down or get a POST_OUT QSB board and use that.

[Argentum]

I will go with the trimming then, how much should I reduce each time 5 cm or 10 cm.

And did it solve such a problem before as it is not loading into Xell even if I gave it few minutes

[BL4K3Y]

The optimum length seems to be 32CM but I suggest working down in increments of about 4CM each time.

Your console isn't booting XeLL because it isn't able to glitch.

[Argentum]

I will try that and tell you if it works thanks man for your fast replies

[Argentum]

I used the yellow wire that was in the phat cables set that came with the coolrunner and it booted instantly. I got my CPU key and wrote my nand.

And now it's working fine. thank you very much. but I had to set CR to slim after writing the nand for it to boot as I booted to Xell with it set on Phat.

Now it boots Instantly I like the speed

[BL4K3Y]

Nice work, I'm glad you got it sorted .