Results 1 to 3 of 3
24th April 12 #1
Burner max Eeprom settings not saving
Hi all, recently i have been getting a few burns which are good but not as good as they usually are using settings provided by DrunkenNinja. For some reason after finishing rebuilding my pc my ihas drive is not saving the Eeprom settings. After a system restart it seems the eeprom setting are reset which led to my burns getting worse. I have been using EEPROM_Utility and i'm sure previously I didn't have to re apply the settings after a system restart. The only thing different i can think of is now my ihas drive is in a sata 6 port instead of a sata 3. I have tried reflashing the drive but still settings will not save. Please can someone verify if the settings are supposed to save and any possible solutions.
25th April 12 #2
They should save. Are you in AHCI or IDE mode? Its probably best to connect it to SATA 1.
Sent from my iPhone 4S using Tapatalk
25th April 12 #3
Re: Burner max Eeprom settings not saving
All my sata ports have been set to AHCI mode. At present the ihas burner is on the sata 3 marvel socket. I have a 3tb sata 3 drive coming today so when it comes i'll switch the ihas burner to a sata 2 intel port as i will need the sata 3 port for the HDD anyway. I'll Let you know.
By astr4twin in forum RGH / JTAG 4 NoobsReplies: 3Last Post: 6th February 12, 09:05