cr4 xl corona v3 - v6

  1. A

    CORONA How to Install CR4 XL with only wires and no QSB's on Corona V3

    Hi, I've gone through a lot of searching to find the answer to this. The best I came across are the following diagrams. Can someone please verify these are the correct solder points for the CR4 XL on a Corona V3? I'd also greatly appreciate it if someone could verify the NAND solder points for...
  2. F

    CORONA Help RGH2 CR4 Corona v4/v6 not booting xell

    Corona V4/v6 Want to RGH2 i have done other installs, my problem is, i have read the nand twice both were the same, created ECC and wrote it, now i have installed CR4 and it looks ok, but, it does not boot into xell, how can i check if the CR4 chip is properly working? I followed UberGeek...
  3. J

    Problem writing ECC on nand

    So I read my nand of my xbox 360e Corona V6 I was able to read the nand just fine and all the nands matched. When I try to write my ECC the motherboard type changes to a trinity and the xbox does not boot. So I would rewrite the nand and try again, nothing. Im using a JRP V2 and a CR4 XL...
  4. Ubergeek

    CR4 XL - SLIM Corona v3 - v6 Install Guide (RGH2+)

    This CR4 XL install guide covers Corona v3 - v6 Motherboards. You can have the absolute latest version dashboard installed if you wish :) FYI yes this covers all the versions with the special Winbond RAM. The last version Corona is v6. The next new version of 360 is called the Winchester which...