fail

  1. afterjo

    GENERAL xecuter 3 frags, 1.6a

    Hello, My xecuter 3 chip fails to boot custom bios. 3 restarts and a frag. What I have tried: Resolder points Tried all bank combinations Tried to boot backup, and without control panel Tried this chip on lower revision xbox https://imgur.com/a/7uFQU#GqVKmtC xbox 1.6a...
  2. N

    16MB Jasper no response

    I tired to do a r-jtag and couldn't boot to xell so i went over the solder again to make sure it's connected but the console isn't responding anymore. The red LED on the CR4 lights up but the power led doesn't come on if i press power or eject. My JR-Programmer 2 can't read/write the nand either...
  3. A

    FIXED Cannot dump - Please HELP

    Drive: Lite-On DG-16D4S (0401) SATA Chipset: VIA 6421 I am unable to dump the firmware/key using JungleFlasher. I am Power Cycling the drive properly using the switch but am unable to dump the firmware.... Please help... Here is my JungleFlasher log: JungleFlasher 0.1.96 Beta (323) Session...
  4. pengekcs

    RGH Corona v2 and v3 - no boot at all

    This is just a theoretical question as I have now given back these 2 consoles. So I had a halo 4 edition 320gb corona v3 (post out bit cut) and just this last weekend a 4gb v2 corona that I have tried every possible combination of a cr3 lite, all kinds of wiring, alt cpu points, xsvf files...
  5. F

    LITEON DG-16D2S Fail Flash Help

    Hello, I think I have a Lite-On DG-16D2S (Its for sure a Lite-On) and I failed at flashing it. I went through everything succesfully. Probing OK Power Cycling OK Writing OK but once I put it in my xbox it kept giving me the open tray error. So I put it back into my pc and then erased the fw off...
  6. Y

    [RGH] Couldn't get NAND anymore

    This is a long story for about 10 days, some failed but some successful, and I do apologize my poor English writing. I have a Jasper 16M, CB 6750 console. As well as Nand-X 3.0 with Coolrunner Ver B. At first, I have NandX wired and try to connect to board and get the nand. But I've keep...
  7. A

    Kamikaze fail fix

    Tools: circuit writer pen draw a conductive layer at the bottom of the drill you made, this will connect the cut traces and probably solve the problems (no eject, no spin ... etc. meaning you unlocked your drive but went a bit far) however try not to fill the whole thing as you may short...
  8. Q

    i need a dummy.bin

    Liteon 0225 Xbox 360 Slim I just bought an xk3y off the internet which cost over 100 bucks. i was looking up installation tutorials when i realized i needed a dummy.bin to use the xk3y. I don't have a x360usb pro or anything of the sort needed to dump my drive. i spent all my money on the xk3y...
  9. N

    I need to know if I can recover from this RROD..

    Hi, I bought a jtag xbox that was dash 12625. It worked fine with no issue. I wanted dashlaunch to be able to boot freestyle dash directly so I flashed freeboot with jtag tool using flash360. the dash version was 12611, I had several warnings that the files were mismatched, following forum...