im stumped for ideas on this one so if i can pick anyones brain over this. Falcon console on latest dash with cool runner installed and all wiring in place correctly. got copies of the nand and made ECC which has been written. ECC was made with coolshrimps coolrunner program. on booting the console with the eject button to boot xell half way thru xell booting up i get 3RROD with error code 0002. ive read up that 0002 is a Network Interface problem. so ive written back the orignal nand file and booted console which starts to boot then 3RROD with 0002 again. ive removed all coolrunner wiring and written orignal nand file back again but still getting 3RROD with 0002 half way thru booting up. ive checked on the board both sides for any stray bits of solder that could of been deposited on the board whilst installing the nand x wiring or installing the coolrunner and the board is clean. so anyone got suggestions ?
GENERAL 0002 after RG install
- Thread starter rohst
- Start date
seanr28 theres no short on either end of the CPU_reset wires
and that area for a short would show up like a sore thumb