RGH 0022 After RGH Attempt

[Sniper Beast17]

I attempted to RGH one of my extra consoles with a coolrunner rev c and JR-Programmer V2. All was going well and I even got XeLL too boot once. After restarting the console to boot XeLL again the NAND points started sparking. Now I can't read or write to the NAND and it 0022's when I try to boot it. Are there any alternate NAND points or somewhere else I can read/write? I was thinking about trying to solder to the traces but I don't think my skills are good enough for stuff that small. Any advice?

Sorry for the picture quality, all I have is an iPhone to take pictures with :\


I might not respond until tomorrow depending on if I pass out or not

 

[Joo C]

The picture u posted is useless. Please fill out the template and help us help u with decent pics.

 

[Martin C]

NAND points sparking? So it sounds like your soldering wasn't up to the job.

Scrap the board, sell for spares or contact someone who does repairs.
(I'm aware that rhymes).

 

[jligg]

You can take very good pictures with your iPhone. Just need to know how..put your board in a well lit area and set focus mode to macro setting for closeups