i attemped my first rgh on a jasper 16mb yesterday.
first i have jatagged alot of consoles so i think my soldering is good.
first i flashed the coolrunner attacched it to the mobo and read the nand , i got 2 maching images and flashed the ecc file.
The xbox boot to xell straight away and i got my cpu key, i made freeboot in jtag tool but then all i got was the centre light flashing green and would not boot into dash or xell.
i checked the wireing wich was good , i then removed the coolrunner and reattached and noticed it was no longer flashing green every 5 seconds.
So i reflashed the coolrunner but it still would not flash green i checked all the wireing again and still looked fine.
after about 5 hours of flashing the coolrunner / freeboot/ecc and resoldering all i got was the centre light flashing green and still no flashing from the coolrunner.
at this point i decided to remove the coolrunner and flash back to stock nand .
in rushing i ripped up the pad next to the hana/ana chip (orange wire i think) and the xbox would no longer power up i fixxed this buy buypassing the pad with a wire directly onto the trace.
now with stock nand all i get is 0022 error after about 7 seconds i followed martins,s tut for rebiulding a stock nand in multi builder and changing the (is it LDV) or number of efuses but all i get is 0022 after 7 second.
first i have jatagged alot of consoles so i think my soldering is good.
first i flashed the coolrunner attacched it to the mobo and read the nand , i got 2 maching images and flashed the ecc file.
The xbox boot to xell straight away and i got my cpu key, i made freeboot in jtag tool but then all i got was the centre light flashing green and would not boot into dash or xell.
i checked the wireing wich was good , i then removed the coolrunner and reattached and noticed it was no longer flashing green every 5 seconds.
So i reflashed the coolrunner but it still would not flash green i checked all the wireing again and still looked fine.
after about 5 hours of flashing the coolrunner / freeboot/ecc and resoldering all i got was the centre light flashing green and still no flashing from the coolrunner.
at this point i decided to remove the coolrunner and flash back to stock nand .
in rushing i ripped up the pad next to the hana/ana chip (orange wire i think) and the xbox would no longer power up i fixxed this buy buypassing the pad with a wire directly onto the trace.
now with stock nand all i get is 0022 error after about 7 seconds i followed martins,s tut for rebiulding a stock nand in multi builder and changing the (is it LDV) or number of efuses but all i get is 0022 after 7 second.
Last edited:
