0022 error need some kind of support

[InfinityLobbies]

ok so i have installed my cool runner to my xbox with the rgh 2 install i have also removed the 2 restores from the cr

the cool runner is flash already "falcon"

i was told my console should boot after i have installed the cool runner no wires are touching and every thing is were it should be i have followed a picture digram

my console will not boot and after about 15 seconds i get 0022 error, if i unsolder the cool runner my console boot fine i really do not get what is wrong or do i install ECC ? :S

 

[nofeloniesyet]

you need to write the ecc file to the console yes,or it wont glitch and will rrod.

 

[Utmad]

ok so i have installed my cool runner to my xbox with the rgh 2 install i have also removed the 2 restores from the cr

the cool runner is flash already "falcon"

i was told my console should boot after i have installed the cool runner no wires are touching and every thing is were it should be i have followed a picture digram

my console will not boot and after about 15 seconds i get 0022 error, if i unsolder the cool runner my console boot fine i really do not get what is wrong or do i install ECC ? :S

Dont keep opening new threads, as I said in your other thread switch to prg on the coolrunner and it will boot if you haev not written anything to the nand if it is on nor it will rrod

 

[InfinityLobbies]

Dont keep opening new threads, as I said in your other thread switch to prg on the coolrunner and it will boot if you haev not written anything to the nand if it is on nor it will rrod

yes i have only programmed my cool runner it is switched to prg and i have not written anything to the nand yet, but the console goes to 0022 ?

 

[Utmad]

yes i have only programmed my cool runner it is switched to prg and i have not written anything to the nand yet, but the console goes to 0022 ?

Post good clear pictures of all the solder points and the coolrunner then

 

[InfinityLobbies]

Post good clear pictures of all the solder points and the coolrunner then

i have every thing wired up correct i have followed the picture digram from j-runner for the rgh 2 install, should i just write ECC to the nand like the other dude said ?

 

[hersheys247]

Why wouldn't u write the ecc file. If it boots up stock when coolrunner is off, then by all means write the ecc switch coolrunner to nor and load up xell. Get cpu key, create glitch image, rewrite and be done already.

 

[Martin C]

Please post in the 'request a service or item' section if you want someone to RGH / fix your console.

This isn't a console repair site - we're here to help you with your TX products.

 

[InfinityLobbies]

ok great now my console will not even turn on but there power going to it because the cool runner is red

 

[unkn0wn.92]

Check STBY CLK point , but i suggest to send it to someone who knows what he do

 

[ModderHead]

ok great now my console will not even turn on but there power going to it because the cool runner is red

Before you write to nand get a nand dump (copy) of the original stock.