You dont need any wires connected to get key, Just connect up usbpro and ck3 lite/pro and get your key. then flash the tx pcb
dale
0225 Flashed now orihinals and backups wont play
- Thread starter Kian1980
- Start date
dale
lol - silly me - of course - sorry...need more coffee lol
haven't had too much to do with slims lol
haven't had too much to do with slims lol
The first key (7A80641962D73A63A20A7B9xxxxxxxxx) was from his dummy, which looks alright..
The second key (D53B9CA4511C9BCFA5C31123166A5829) was from LT+.. Jungleflasher shows this key when loading the firmware here also..
The log shows key was copied from source to target, so everything looks alright..
You dont need to put the original PCB back in the drive and solder the wires in order to pull the key.. Just connect it to a CK3 and voila..
Anyhow, if it was a key-problem.. Wouldnt it show "Play-DVD" instead of open tray?
The second key (D53B9CA4511C9BCFA5C31123166A5829) was from LT+.. Jungleflasher shows this key when loading the firmware here also..
The log shows key was copied from source to target, so everything looks alright..
You dont need to put the original PCB back in the drive and solder the wires in order to pull the key.. Just connect it to a CK3 and voila..
Anyhow, if it was a key-problem.. Wouldnt it show "Play-DVD" instead of open tray?
For erasing the TX board do i go MTK Flash 32 click into / device id make sure the dot is in slim then click erase.
Just want to get all this correct
Just want to get all this correct
Hi guys I have done the flashing again as advised and advised how to do it but everything is still the same here is my new jflog
hmm strange one this is as i personally use the tx unlocked pcb in my 0225 and didnt and dont have any problems, can you double check your laser ribbon cable is inserted and also if you are using a new laser have you removed the safety solder ball for the laser to work?
So you extracted the key again from the original pcb and flashed it to the tx pcb ? correct ? and your still getting the same problem ?
so to eliminate problems:
it was originally a 0225 (it wasnt 9504 on drive case but JF said 0225? )
you have connected the wires correctly in order ?
you have tried to extract key from original & flashed with JF1.84?
Reflash your tx pcb with JF1.84 and not JF1.85
dale
I have done all the above but havent flashed the TX with jungleflasher1.84
Sorry forgot to say it was originally 0225
Sorry forgot to say it was originally 0225
Last edited:
If all that fails, put the original back on and see if it plays the games. If it does its def got something youve done to the TX pcb
Is the 0225 a MXIC or a WINBOND?
dale
Trying to use Jungleflasher1.84 to flash tx board but it keeps freezing and coming up saying not responding and thats just trying to get it into vendor mode...........................I feel like im doomed lol
not sure about using the old jungle flasher as i have never had problems with the new one, where abouts are you located?
your using onboard sata ? yes ? that could be a problem too, better off with a usb pro
best off sending it to see if theycan do owt with it. I could if your in the UK
If not look on here if your in another country
dale
Im from Worksop (Nottinghamshire) I am using x360usbpro, reason for trying the jugleflasher1.84 is that it was recomended to me to flash the tx board using 1.84 and not v1.85