0251 stuck at status 0x80

[tpuntspunt]

Hey guys,

for some reason i cannot start a new thread, so i post it in this related thread.

I have this lite-on drive. Everything went wel but then it stuck at writing bank 3.
now jungleflasher won't recognise the drive anymore and it wil get stuck at status 0x80 when doing te l-o erase.
All posts concerning the same problem are dated a long time ago, but not a single solution i found has worked so far.

here is my log:

JungleFlasher 0.1.96 Beta (323)


Session Started Thu Oct 17 11:36:54 2013






This is a Wow 64 process running on 6 x 64 bit CPUs


portio64.sys Driver not Installed


XECUTER X360USB PRO attached.






Found 0 I/O Ports.


Found 1 Com Ports.


Found 5 windows drives C: D: E: F: G:


Found 2 CD/DVD drives D: G:






PortIO unloaded.






Sending Lite-On-Erase request to port 0x0000


..............


Drive returned Status 0x80


....................


Device Intro failed!


XECUTER X360USB PRO removed.






XECUTER X360USB PRO attached.










Sending Lite-On-Erase request to port 0x0000


..............


Drive returned Status 0x80


....................


Device Intro failed!


Thanks for the

 

[Martin C]

You couldn't start a thread in the tutorials section because you're not permitted to do so.

I've moved your post to a new thread in the firmware for noob section instead.

If you cant intro after erase then the PCB itself is probably at fault.

 

[tpuntspunt]

Thanks for the reply,

by PCB you mean the circuit board of the Lite-on?
Is that possible while it worked a few hours ago? I did get 0x72 then. Now a bad flash and status 0x80. I do hear the lite-on making a noise if i listen closely, so it is not fried I assume?

 

[gazcoigne]

pcb = printed circuit board

 

[Martin C]

Do you get the drive detected in JF at all (in the bottom left)?

 

[tpuntspunt]

ow okeey. But what exactly is that? is that the circuit board of the xbox, the lite-on or the x306usb?
And what do I have to

edit:
JF can't detect the drive anymore. But that's because the l-o erase worked the first time. So it is without firmware now.
It detect it before the first l-o erase attempt

 

[Martin C]

Where? The clue is in the question.

"Do you get the drive detected in JF at all(in the bottom left)?"

 

[tpuntspunt]

There is no drive detected in the bottom left of JF. But that is as should be right? because firmware was erased at the first attempt.

 

[Martin C]

If there's no firmware and when you're power cycling the drive during device intro, the 0x80 should change state. If it stays 0x80, you don't have a connection. Make sure that 'phat' drive type is selected.

 

[lesta_smsc]

I had same problem. Allow jungleflasher to keep sending me the status detect. Open and close drive manually until status changes.

Sent from my GT-I9300 using Tapatalk 2