LITEON 9504 0272 Drive Winbond Kamikaze Drive Problem

[scarface1]

I did this method and everything worked perfect it seemed i pulled the key before hand also. Ok i stopped doing the kamikaze drill part right when it beeped read the firmware did everything flashed it relocked it back and now my drive it takes a few times to hit the eject button but the drive ejects either half way or all the way very fast if its all the way. But does not want to close did i go to deep on the hole or is this another problem that can be fixed. i was searching through the forums and did not see anyone that had the same problem as mine. Any help would be great i mean if i have to get a new pcb board so be it but would like to see if i can get this one working right first.

Thanks.

 

[lockpicker]

i gave up on the tray eror, it opening fast etc etc i just bought a tx unlockd board, far easier and better to use..went to deep n thats what caused mine to go weird

 

[mgrover]

try the POUT fix, theres a picture laying around the forum somewhere here

http://www.xecuter.com/forums/showthread.php?t=70138

 

[scarface1]

does not hurt to try it ha thanks for info and that will see

 

[scarface1]

ok went to radio shack they have a 51 ohm there but its 1/4 watt and they have 1/8 what is there a certain one i need or are these the right ones if not were can i order the right ones.. Is it better to do 62ohm but they dont have any of those either anyways all help is much grateful thanks guys for your time.