LITEON DG-16D4S - SLIM 0401 drive not being detected in jf

[neural]

before i explain im not a noob but i did make a schoolboy error as i was tired at the time
i was asked to flash a slim and ordered a switch to unlock after looking at the chip thinking it was an 03 but as i was tired i read wrong and its an 05 but (and heres the eror lol) i grabbed the key/firmware then soldered the switch then realised it was 05 now jf isnt recognising the drive in device manager it shows as spif30x usb2sata bridge usb device
i cant intro it or anything can anyone shed any light on it
and would doing the kamikaze help?

 

[BL4K3Y]

Are you using an X360USB Pro?

If so, ensure "USB Only" is ticked (port 0x0000).

 

[muchose]

Have you removed the switch and resoldered the trace cut?

Also, if using X360USB Pro, just relflash the firmware on it.

 

[neural]

yes im using x360usbpro and yes drivers are in properly i have done about 20 slims so far even kamikaze hacks i just made a stupid error through being over tired

 

[muchose]

But right now, if you only plug the X360USB Pro (no dvd drive), what does it come up as in the Device Manager? spif30x usb2sata bridge usb device?

If so, reflash the firmware on it.

 

[neural]

not yet but i presumed all the switch does is open and close the trace and put a resistance in between the cut ?
i will unsolder now and connect the trace

 

[muchose]

Nothing should of gotten damaged. Lots of noobs have made this mistake. Just return the drive to stock (remove switch and resolder trace), and make sure the X360USB Pro is still being recognized in Device Manager. If not, reflash.

Like BL4K3Y said, make sure on tick USB ONLY.

 

[neural]

i didnt actually flash the drive it never got that far when i plug my slim drive in it comes up with usbpro in device manager same with an 0272 drive i have here
comes up with sata bridge under drives i should of said instead

 

[muchose]

Reflash firmware on the X360USB Pro.

 

[neural]

but all the other drives are working slim and phat its just this one

 

[muchose]

So currently other drives are ok? Did you test another drive just now?

 

[neural]

yeah tested 2 slims and 2 phats all fine just reflashed the usbpro firmware too and still no go

---------- Post added at 00:14 ---------- Previous post was at 00:04 ----------

noticed these getting extremley hot when plugged into usbpro and the xbox

 

[muchose]

Maybe someone can shed some light here, cause I'm at a lost. I don't believe cuting the trace on a Winbond would results in the problems you are having, but of course, I may be wrong.

Good luck.

 

[neural]

thanks for the help

 

[Martin C]

Pics of the damage you did to the board, please.

 

[muchose]

lol. so direct...

 

[neural]

yer a cheeky bugger martin lol

circled is where i joined the trace cut back up, i havent got round to removing excess solder yet as it was late last night

 

[muchose]

Are those shorting on the trace next to them? By the looks of the pictures, it looks like they are both shorting out.

 

[Martin C]

Edit: muchose's edit is more accurate than mine...


You also said you did a Kamikaze, yet no image of it....

 

[neural]

no they arent touching, i have removed the excess solder now
i havent done kamikaze on this yet i was just asking could that possibly solve a problem but as the board isnt recognised in jf im guessing it wont