the usual 3 boot frag.
BUT
the control pannel works perffectly... and so does the user interface with power and reset buttons...
(quick press, long press, flash both press)
the chip off feature does go to ms dash....
the chip on feature frags...
and flash just hangs... then eventually the front led's both turn on (power led's) in my case making it purple (i have blue/red power leds)
no video in any chip on mode
this is a problem ive had for over a month now, soldering resoldering... trying different methods (direct connect non-rebuilding lpc method) (pin header) (wire install) all seem to get me the same results
i have attempted the chip with just the d0 disconnected... it frags much faster then when its connected... so im led to assume it ssomthing the chip checks for after the d0 (aka not a d0 problem?)
BUT
the control pannel works perffectly... and so does the user interface with power and reset buttons...
(quick press, long press, flash both press)
the chip off feature does go to ms dash....
the chip on feature frags...
and flash just hangs... then eventually the front led's both turn on (power led's) in my case making it purple (i have blue/red power leds)
no video in any chip on mode
this is a problem ive had for over a month now, soldering resoldering... trying different methods (direct connect non-rebuilding lpc method) (pin header) (wire install) all seem to get me the same results
i have attempted the chip with just the d0 disconnected... it frags much faster then when its connected... so im led to assume it ssomthing the chip checks for after the d0 (aka not a d0 problem?)
