1.6 fragging problem with or without the chip on.

[kanja]

I just installed a 2.6CE into a 1.6, I didn’t have a LPC rebuild so I just did the wire method.

The xbox frags green/red with the chip ON or OFF. I read that this is a problem with the D0 point, but I can’t find a good way to test this with a multi meter. Where is the alternate D0 on the TOP of the board? I just want to test it as I’m afraid I burnt out the one on the bottom.

If it was a bad connection to D0 then I would think that the xbox would still boot without the chip, unless I damaged something. I need pictures of what contacts I can test to verify I didn’t damage anything.

http://www.gr8r-x.com/images/lpc_repair_guide.jpg

This picture is exactly what I need but for the 1.6! I also need to know the alternate points for D0 so I can test them as well. I have been searching for the last few hours so any help would be appreciated.

 

[DJBOOBY]

if its fraging then check your soldering
check for solder splash as well as bad trace
look for a coldsolder
its not the d0

 

[Fantmx]

Remove everything, inlcuding the LPC rebuild board. Your goal is to get the Xbox working again without the chip, and then you can go from there.

 

[Floppy Mohawk]

I just installed a 2.6CE into a 1.6, I didn’t have a LPC rebuild so I just did the wire method.

What exactly does this mean? Did you or did you not rebuild the LPC?
Where did you connect the DO wire?

If you look at the HOME PAGE of this site on the right hand side you will see a XBOX! HELP section. You will see a X3/X2.6 v1.6 install guide.
Unfortunately this guide does not show an alternate DO point. But the Install X2.3B to v1.6 guide does.

Floppy