1.6 Xbox X3 modchip problem

[AJS85]

Ok the chip is installed and all the soldering looks good
When you go to boot up with the modchip bios it turns on and off 2 times then goes to the green/red flashing
When booting up with the chip disabled the xbox works fine

Could it be the soldering and i should redo it?

Any ideas

 

[custardboy]

yeah check your soldering,could be just one pin not connectiong.did you use the re-build board?make sure all points are making a good contact

 

[AJS85]

yeah just checked the points with a multimetre and they seem to be all coneected to the board i'll check again and make sure.
Any ideas if it's not the soldering
the switch is on on off off off

Edit yes rebuild

 

[Ikarasu]

It's the soldering...

Do both LED lights come on your Xecuter? Re-check/Re-do all the soldering, it is 99.9% the problem

 

[AJS85]

Yeah has to be the soldering. only 1 led
Which points are most likely to cause this?

 

[tehsoul]

check this tut
http://www.teamxecuter.com/forums/showthread.php?t=7768

go over all the solder points here and count yours

 

[aloo]

check the d0 point