1175 on a Corona 4gb... Installing a replacemned PCB

[justice91423]

I have a Corona 4gb 360 with a 1175 drive. My goal is to have the drive running LTU v1.2 with a replacement PCB. I do not want the Coolrunner or the glitch hack installed permanently

I'm following this tut to dump the nand and write the Xell image.

I'll then install the Coolrunner to boot in to Xell to get the drive key, and then flash the LTU replacement PCB.

My question is... Do I need to then go back and restore the nand to Stock? If so, how do I go about doing that?

Thanks

 

[stefanounick]

http://team-xecuter.com/forums/showthread.php?p=720650

LTU Tutorial

Sent from my Nexus 7

 

[justice91423]

http://team-xecuter.com/forums/showthread.php?p=720650

LTU Tutorial

Do I have to have a DGX or will my CR3 Lite work?

 

[stefanounick]

if its on 14719 or lower you can use the lite
asides from that, the process is exactly the same

Sent from my Nexus 7

 

[WoofDowgz]

If your just going back to stock you just want to rewrite the original nand file after pulling the key. In advanced mode just load original nand and hit write.