2/3 loader bar stop

[mcs1]

Hi,
Sorry to open a thread with my first post
I have installed a xecuter 3 CE in what I believe is a xbox 1.6b (Hynax chip?). Did not read enough so I flashed the box with switch position on on off off off, i.e., flash bios 3.0.1. It stopped to flash after 2/3 and a reboot resulted in a frag.
Now switch to off on off off off and I still get flash bios 3.0.1 ? Backup bios is the same, 3.0.1
I tried to flash again (first switching to on on off off off) but same effect.
Any ideas what to do?
Thank you very much for all your help
MCS

 

[DJBOOBY]

try flashing with bios switch removed

 

[mcs1]

Great!!!!
Works now! Thank you very much!
But only without the switch.
Any ideas ?
Cheers

MCS

 

[DJBOOBY]

if its not pluged in right it will do this check pins were it plugs into chip and x3 bios switch you can buy a pro switch to replace x3 switch

 

[mcs1]

Hi,

Thank you very much for the info. I will check on the chip, because I unplugged on the switch and that seems ok.
Thanks again
Cheers
MCS

 

[mcs1]

All pins look fine and on both the chip and the switch. I noticed it does boot with the switch in the off off off off off position.
Any more ideas ?
Thank you for all the help
Cheers
MCS

 

[DJBOOBY]

counld be a bad switch or chip try with pro switch