2.6 and a 1.6 xbox
- Thread starter Tank_Killer
- Start date
I think you need to flash the chip with the 1959_16 bios not the M8 bios.
This should allow the chip to function correctly. Hope this helps.
8)
This should allow the chip to function correctly. Hope this helps.
8) Liteon93450c can not dump Using Boxxdr-status 0x51/0x52 only
I have the same problem as this:
http://forums.xbox-scene.com/index.php?showtopic=701509
Even used the latest JF and tutorial v1.70. Has someone discovered a good method that would work on some of these stubborn Liteon drives?
Problem now solved Feb 10-2009. Just lowered resistor to 18ohms and did the downpower/repower withing 1 sec. trick after the yes on MTK vendor.
I have the same problem as this:
http://forums.xbox-scene.com/index.php?showtopic=701509
Even used the latest JF and tutorial v1.70. Has someone discovered a good method that would work on some of these stubborn Liteon drives?
Problem now solved Feb 10-2009. Just lowered resistor to 18ohms and did the downpower/repower withing 1 sec. trick after the yes on MTK vendor.
Re: Liteon93450c can not dump Using Boxxdr-status 0x51/0x52
Just so others know, if you get 52, then you should try a lower resistor than 22ohms, as pnunez discovered!
9 times out of 10, 52 means there is still sufficient power to the embedded spi, so the controller wont be tricked into thinking it's erased (in laymans terms)
Just so others know, if you get 52, then you should try a lower resistor than 22ohms, as pnunez discovered!
9 times out of 10, 52 means there is still sufficient power to the embedded spi, so the controller wont be tricked into thinking it's erased (in laymans terms)
Re: Liteon93450c can not dump Using Boxxdr-status 0x51/0x52
I have an 83850 ver 2 and im down to 16 ohms and still get 52
I have an 83850 ver 2 and im down to 16 ohms and still get 52
Re: Liteon93450c can not dump Using Boxxdr-status 0x51/0x52
Yes, triple check your connections and follow JungleFlasher 1.70 tut. using the switch for reading and writing. Remember to do the MTK under 1 second.
Yes, triple check your connections and follow JungleFlasher 1.70 tut. using the switch for reading and writing. Remember to do the MTK under 1 second.