2.6 CE problems

[romeo11523]

I have just modded my Ver. 1.0 xbox with an Xecuter 2.6 CE. I did a wire install and successfully got flashbios to come up. I got on xbins and downloaded the bios I thought I read in the tut to use which was X3_1463. I made the iso disk and flashed, the xbox turned off and when it came back on it went on and off/on and off then started blinking red/green. I switched to bank 2 which I never touched and the same deal. It will however boot to ms dash when switched to bipass the chip. I need some help, do I need to buy the USB programmer?

Thanks,
Ryan

 

[DJBOOBY]

you flash a 1mb bios to your chip the wrong bios for x2 chip bios size needed 512k
you needed to flash with
x2 5035 v1.0 to v1.5 xboxs (512k)
x2 5035 v16 plus v1.6 v1.6b xboxs (512k)
yes you will have to buy a programer or if you have someone with a x2 or x3 chip that will do a hotswap is the other option