I am modding an xbox for someone and I got the chip installed fine but I get the on off on off on blinking lights. I checked the voltages on the lpc and I think they were correct. I was looking at readings for an older version xbox. If someone could post how the pins should read it might be helpful. I think I rebuilt the lpc correctly becuase i was reading voltages from the pins i soldered in and not the various points on the board.
When the chip is turned on is when this is happening. If i leave it installed and turn it off the xbox works fine so at least nothing is damaged. I resoldered everything and it still happens. Is there anything else I could check to make sure it's soldered properly?
If you have any tips or help I would be very grateful.
When the chip is turned on is when this is happening. If i leave it installed and turn it off the xbox works fine so at least nothing is damaged. I resoldered everything and it still happens. Is there anything else I could check to make sure it's soldered properly?
If you have any tips or help I would be very grateful.
