2.6 Solderless Frags after Flashing

P

pscholes18

Full Member
Jan 29, 2004
54
0
Ok people, Im doing a 1.0/1.1 box using the Xecuter 2.6CE Solderless chip. I intalled the xapt3r fine. The pin wire light is red but it still worked. Anyway went ahead and put on the chip to the adapter and tightened it a bit and everything worked fine. Bios screen came up and I flashed the chip on bank 1 with X5029 from the HDD Im using for the box. Box tunred off. I turned it back on and everything was working fine. Turn the box off, pull out the controller plugs to insert the switch to the bottom of the box. Turn the box back on and it Frags. Nothing comes on the screen. Just frags. Turn the chip off and box on, it boots up to the error message becaose of the hdd. ANyways, I need suggestions. Ive tried two different switches after it fragged and still no luck. Anyone help woud be appreciated.
 
D

DJBOOBY

VIP Member
Sep 24, 2005
5,354
0
Australia
solderless here we go again recheck your install any movement of xbox can make the solderless have a bad seating on mother board recheck it again
ok your hard drive is out of a modded xbox i take it
was it unlocked before you removed from modded xbox before puting in your xbox
the switch need to be connected so x2 will work so you can flash it
have you try the diff bank on chip banks 1 or 2
is the chip enable on switch
 
Last edited:
You must log in or register to reply here.