Can you take the CR4 onto Xbox live? Now that I have successfully installed the CR4 should I put Hot glue over the points to ensure that don't come loose???? I know I use to do that with controller modchips.
2 quick questions about CR4
- Thread starter Nelskeet517
- Start date
GeekHeat
VIP Member
rgh/jtag xboxs shud not be connected to xbox live. its not necessary to use hot glue but u can do if u want. if your wires are cut to length and your soldering is good then its not really necessary.
I remember on an earlier post that u had over 30 xboxs that u were going to modify. hopefully each one u do u will learn as u go along.
I remember on an earlier post that u had over 30 xboxs that u were going to modify. hopefully each one u do u will learn as u go along.
Last edited:
you should know by now that you cant go online with Jtag / RGH or anything unless you have a demon fitted , as for glue I use glue spots I got them off Ebay they come on a roll , little blobs of glue just stick one on the board where the wire is going to lye and place wire on it
jligg
VIP Member
that's why I don't use hot glue because its messy and a pain to get off if you need toLittle tip. Never hot glue over a point..glue wires just before the point. If you ever need to repair or make changes you will lift the point when trying to remove the glue..commen sense
Actually, it's quite easy to get up. A little isopropyl alcohol and it comes right up. I've never ever had an issue with pulling off components. The alcohol has a way of working itself under the glue a weakens it bond.