Ok so I've done 2 slims no problem - Today I tried my first jasper RGH. Dumped, created/wrote ecc, installed the programmed x360Glitch chip (i'm waiting on more coolrunners and got impatient) after I got it all wired up I tried to boot it up but got 2 red lights instantly - And not the 2 overheating red lights. If it was horizontal it was the top Right and Bottom left at opposite corners. I removed all wire from the chip (still attached to the board) and still got the same lights.
Anyone know what this is? I'm going to write back the original nand to see if it still boots just curious as to if it could just be something simple before starting over.
Anyone know what this is? I'm going to write back the original nand to see if it still boots just curious as to if it could just be something simple before starting over.
