RGH 256Jasper 6750 wont boot image 12 the time

[shawndezy115]

so i installed a CR in a Jasper 256.
no problems up until i flash the image from multibuilder.
it boots every single time first or second glitch into xell.
booting into XMB is about 50%. half the time it boots right in. the other half it stops blinking like it glitched

any ideas. standard install, cap between GND and A.

IDK. HELP

 

[Mickey3177]

Did you adjust your wires to this layout:
http://team-xecuter.com/forums/showthread.php?t=75787

 

[shawndezy115]

ya thats the way i had the. i just moved the yellow a little down and the blue a up near the green. now im getting a 2/3 on boot into image

Update. replaced cpu-reset with a piece of cat 6 and ran it under the fans and now im getting 9/10.

 

[keith6625]

i would keep try diff wire config's i have done 5 BB jaspers now and they all were a little diff on the wires



i have also ran them this way

sorry for the crude pic i dont want to open the console to take a picture

 

[Mickey3177]

Update. replaced cpu-reset with a piece of cat 6 and ran it under the fans and now im getting 9/10.[/QUOTE]

You ran it under the fans?

 

[shawndezy115]

YUP. i found a more insulated cable. ran it along the cut out where the fans go then strait to the point.

Im now getting 20/20 on boots with one taking 30seconds. i can live with that. 99% of the time is first or second glitch. im satisfied with that

UPDATE: i put it back together and now it boots 4/5 times. WTF im going crazy
im going to bed. any thoughts

 

[triquetrium]

AA--,

 

[shawndezy115]

so i messed with it this morning. still getting 4/5 boots. the one failed boot the green light stops flashing like it glitched, but it doesnt boot. it boots into xell 100%.

ANY IDEAS

 

[keith6625]

i would say it has to be the wires still did you pinch any wires when you put it back together i also read that if any of your wires are touching your dvd drive it can mess with them as well

edit and jaspers are a big pain sometimes too