3 Rings - Falcon PHAT, RJTAG,

[anthonyp]

Hey everyone. I've been at this for 3 days running back and forth with soldering and the 3 rings.


Here's everything I've done and I hope someone can give me some advise. Basically I am trying to RJTAG a Falcon using the CR4 and ran into some soldering issues.


1. I managed to dump my nand successfully but did not write the ECC.
2. I lifted a 2 PADs and had to jump to CPU_PLL_BYPASS and CPU_RST. -->
Image (Lifted PAD's): https://www.dropbox.com/s/zi21j0bjlk6e012/1.jpg?dl=0
Image (CPU_PLL_BYPASS): https://www.dropbox.com/s/ujl0pbmyx08o078/2.JPG?dl=0
Image (CPU_RST): https://www.dropbox.com/s/gcialm5e2tqaz2q/3.JPG?dl=0


Other than this, everything worked well. Here are more pics:


- https://www.dropbox.com/s/c076biz2v73xjzr/IMG_2633.JPG?dl=0
- https://www.dropbox.com/s/jibz47rlp33keh2/IMG_2634.JPG?dl=0
- https://www.dropbox.com/s/kdjaj4kvx2078iy/IMG_2638.JPG?dl=0


Now I'm trying to boot into retail and the rings are popping up. From the pics can you identify exactly what's going on? I'm ready to name my 2nd child after the person who can help me through this!!!!

 

[Running4Hippos]

------------Deleted, Look at Post Below-------------------

 

[Running4Hippos]

https://www.dropbox.com/s/kdjaj4kvx2078iy/IMG_2638.JPG?dl=0

You didn't solder the point to the resistor

I suggest you get desolder braid remove the qsb realign it and solder it properly (Desolder Braid - http://goo.gl/B1RHEL)

http://goo.gl/IMd1jA - Here's what I mean

Taken from - http://team-xecuter.com/forums/thre...on-Setup-Guide-***-UPDATED-JULY-26th-2013-***

Here's what it should look like

http://goo.gl/RLu290

Make sure it is set to ON

If you want to keep going, it's okay but just becareful not to kill your xbox, and next time make sure to double check your soldering

Here is a good TUT on YT - https://www.youtube.com/watch?v=1sP3fuo_n1Y