Hi,
I'm installing an X3 mod chip on a 1.6 machine.
Right now, my machine wont even turn on (I've already seen the posts refering to the 2T and will check that asap) after it seemed to have worked ok With the HD and DVD not connected (that is - both power leds went on smoothly and I seemed to be able to boot in either blue, red or purple modes), when I tried connecting them and then boot it, it started twice and turned itself off, and then wouldn't start now more, with ot without HD and DVD.
One thing that seemed strange to me is that I found out I only have 31Ohms between my pin 15 and the ground (which causes my multimeter to beep nicely for them in continuity check mode), I'd be very thankful if someone with a working machine could check the resistance between the two and post it here, I'm afraid I might have semi-shorted them somehow (couldn't find no bridges or spills, but perhaps I'm missing something).
Thanks for your help!
I'm installing an X3 mod chip on a 1.6 machine.
Right now, my machine wont even turn on (I've already seen the posts refering to the 2T and will check that asap) after it seemed to have worked ok With the HD and DVD not connected (that is - both power leds went on smoothly and I seemed to be able to boot in either blue, red or purple modes), when I tried connecting them and then boot it, it started twice and turned itself off, and then wouldn't start now more, with ot without HD and DVD.
One thing that seemed strange to me is that I found out I only have 31Ohms between my pin 15 and the ground (which causes my multimeter to beep nicely for them in continuity check mode), I'd be very thankful if someone with a working machine could check the resistance between the two and post it here, I'm afraid I might have semi-shorted them somehow (couldn't find no bridges or spills, but perhaps I'm missing something).
Thanks for your help!