RGH 360 Slim Coolrunner issue

[Darius02]

hi,
I got a problem and seems some people had the same issue...
but Ive been unsuccessful...
I programmed the coolrunner with Jrunner latest build... the LED green light doesnt turn on it maybe flicks just a few times then stays off
I can boot into the system when the chip is turned off...

also the CLK wire... first try i accidentally peeled away the point B and I had fried the resisitor chip...so for point B I used the alt point on the underside

I did some research and the chip i needed had to be... I think... 39 ohm? but I had no luck finding one and ordering one I had no money for... so i took a dead ps2 used a 30 ohm resistor chip... does that have to do anything with the coolrunner not booting?
cause it boots up well without the chip...

I checked the rst cable as well I followed some ways none worked like coiling around the x clamp letting it loose.... @@ Im in ove rmy head maybe I'll sell it or trade for a phat that has an older dash been frustrated with this damned console lol well any advice would be helpful
I checked all my soldering points too

 

[x360ccm]

post some images off your install and the damaged point good clear images.

and its a 34ohms 0603 smd resistor you need to replace the one with.

you wont get much help without posting images of what you done.