Hey guys, im interested in mounting a temperature sensor on my trinity slim. I see a lot of people just putting temperature probes as close as possible to the CGPU. Im interested in getting a more accurate reading.
For example: 360's running custom firmware can read and display the temps on the dashboard, so there must be a trace on the mobo that carries the temp right?
Wouldnt it be possible to piggy back off that trace?
If it is possible, anyone happen to know where its located?
Any help would be much appreciated!
On a side note, i was wondering if anybody has noticed that some heatsink legs are about 0.4cm too long and warps the board when in the metal case. Ive owned two corona mobo's that dont have this problem but my trinity does.
For example: 360's running custom firmware can read and display the temps on the dashboard, so there must be a trace on the mobo that carries the temp right?
Wouldnt it be possible to piggy back off that trace?
If it is possible, anyone happen to know where its located?
Any help would be much appreciated!
On a side note, i was wondering if anybody has noticed that some heatsink legs are about 0.4cm too long and warps the board when in the metal case. Ive owned two corona mobo's that dont have this problem but my trinity does.