RGH 3rrod 0010 after soldering coolrunner?

sk8man124

Full Member
Mar 31, 2011
55
0
so i managed to read my nand using jrunner and got matching dumps. while following the pdf guide it then said to flash the coolrunner and then boot my device. within one second my device shows three lights and 0010 code. i have a 256 jasper and the A point on the coolrunner i somehow managed to lift so i soldered to an alternate point. although these shots are low res, take my word they seem hesitant to move so i believe there is solid connection. also, my power brick just stays yellow during all of this. the bridge point on my rev b was also bridged before any other soldering/ nand dumping

---------- Post added at 00:17 ---------- Previous post was at 00:14 ----------