4GB corona (V2) Lost CAPS...

[Ac1dR3d]

Hello everyone.

So this is

Mobo: Corona V2 4GB

dash: blah blah...

attempts: RGH 2.0

issue: beep only after power signal.


long story short... I have tryed to convert it to 256MB took falcon/jasper NAND chip soldered it... and at one time i had even signal from nand on my j-r programmer.... so anyway... then i figured out i didnt remved some CAPS....

So on my way of "fixing" this baby... i have removed some CAPS around the NAND.... wich i by my foolishness have lost... I'm just hoping that here is someone who knows theyr masures so I could replace them... dont have any other dead 4GB coronas to experiment on... please help if you can... THANKS!!!

oh and picture

thanks again.

 

[Ac1dR3d]

oh deam... ive read you dont even need them... sikes..

 

[chase]

each one of them caps are approx 180uF from what I remember

 

[Krafter]

It should boot without C1E12 and C2E1. Those are just filters for the NAND. I suggest replacing them but just as a test, it should boot.

I thought about putting a 512M on a conversion I just did but I wasn't sure of the resistor positioning on the bottom side. I do know they will not be the same as a 16M.