RGH 50 ohm double shielded cable width?

[pudinkk]

Sidenote on these cables, especially with the LMR100 which is singlecore, better add ~2cm very thin multistranded extension wire which connects to the motherboard pad and adds a little slack because the tension these heavy wires add to the connection point could end up with a ripped pad. (just happened to me with FT4R2)

Well that's sorta common sense. This cable is also best used with the POST QSB as using 30-50cm coiled is nearly impossible.

Only time this cable should be soldered directly to the motherboard is with Phat HDMI RST and Xenon's.

guys can you please post images of the cables installed on the mobo?with the extension cable you have figured?

from what I gather from the post people dont suggest to go for rg-174 or rg-178?

they advice to get LMR-100A low loss.

 

[pudinkk]

mine are 2mm width and 22cm length. original alt point under the mobo passing thru between the fan and the mobo. boot are instant.

and the wire you were using was?
LMR-100A?