512 jasper long boot times for xell

[shawndezy115]

so i tried my first RGH2.
big block jasper everything went fine.
used jrunner
flashed ecc. and it seemed nothing.
but if i let it sit there for 5 min or so it will boot xell.
built my image and flashed it. still the same. but it wont boot into dash at all.

i have tried the resisters 10ohms 11ohms 15ohms 20ohms and 25ohms

pretty much the same result

i have rg174 cable. could not find lmar100 locally.

i even grounded the shielding bc some ppl claim it helps.

i tried bottom connection for CPU reset and the ALT point on top. using the full 12" legnth.

same result.

tried using different timings.

same result.

long load times to xell.
NO dash.

any ideas?

512 jasper 6752

 

[Shadowlance]

I'm having the same issue, boots xell after about 3 minutes and wont boot dashboard, seems alot of people are having that issue. Hopefully there is an update or something, at least it boots xell now though lol

 

[zackf89]

Theres currently an issue with Xebuild and Jaspers with building hacked RGH2.0 images, it is currently being fixed

 

[shawndezy115]

so has there been any development on boot times yet for the jaspers.
i updated my images with jrunner and it does boot now. but it still takes 3-4 min to do so.
have tried different resistors.
tried bridging the cap
tried grounding my sheilding om my RG174 cable.

still takes forever to boot.

please help

 

[spandaman]

so has there been any development on boot times yet for the jaspers.
i updated my images with jrunner and it does boot now. but it still takes 3-4 min to do so.
have tried different resistors.
tried bridging the cap
tried grounding my sheilding om my RG174 cable.

still takes forever to boot.

please help

Each box is different, my jasper 512 boots from instant-10 secs and I'm using a rev A Coolrunner, no cap's and no shielded wire.


Sent from my iPhone using Tapatalk