512K TSOP flash, oops, how to boot from the right bank?

[beamer_nkh]

Yeah, I really screwed the pooch this time...

I flashed two TSOP's the other evening worked fine...

this time I flashed the TSOP (ST) with 5035 (forgetting to make it a 1,b file) not it frags... I looked into it and see that you can boot to 1 of 4 banks on this chip, each 256K...

Anyone know of a way that I can install a switch to boot from a 512k bank size?
Anyone know which bank raincoat would flash to default, I hear it's bank 4 for a 256k bios... how about a 512K...

I do have a chip I could install, but...

 

[beamer_nkh]

got it... new problem... I installed a switch to split the bios and I can boot my Xecuter 5035 (512K), but when I try to flash a new 1mb bios (after detaching the switch, I guess I could just turn it off...)to take-up the entire chip I can't, it stops at half... but it still will boot... (xecuter)

Is this because I booted from half the tsop?
Is there a way to boot from half the TSOP and Flash the Whole? Or can you only flash the part that you accessed for the boot?

Damn

 

[Fantmx]

This forum is dedicated to Team Xecuter mod chips, not softmodding. You would probably get more responses if you posted on the xbox-scene.com forums in the softmod section.

 

[beamer_nkh]

figured it out, apparently the bios I put in the slayer was 512K, so it would (for some reason) stop halfway... re-burnt slayer with a 1024K, booted with the switch on, turned it off, flashed with slayer, works great...


...just in case anyone ever sees that...

...thx FantmX

 

[Martin C]

You may be better looking at the TSOP forums on Xbox-Scene.com.

I'm pretty sure if you disconnect the switch after booting the 512k Bank, you should be able to use Raincoat to flash the entire chip.

Martin