FIXED 512MB Jasper CR4 Demon Install

G

gavin_darkglide

VIP Member
Dec 14, 2012
2,303
118
if it is turning on with the 16mb ecc image, then the problem falls to the cr4. I have read that rgh2+ preforms better on jaspers. now that you know the demon is working, you need to focus on the cr4.
 
  • Like
Reactions: CAVO12
C

CAVO12

Full Member
Jun 27, 2012
67
0
I wired it for RGH2+ and shorted some wires while I was at it and it boot xell no problem. I think when I wired it for RGH2+ the last time I forgot to flip the dips. I will let y'all know if I have any problems. Once again thank you so very much
 
C

CAVO12

Full Member
Jun 27, 2012
67
0
I don't know if it's a problem with my install or a problem with Aurora or dashlaunch, but it seems to freeze. I don't know if it's my install or my dashlaunch settings. It boots anywhere from instaboot to a minute. it seems to only freeze when ejecting the dvd drive or plugging in or removing flash drives, but consistantly it freezes on dvd eject press. Any ideas?
 
C

CAVO12

Full Member
Jun 27, 2012
67
0
I figured it out. It was either a bad flash or a hack job of soldering on my DG-16D2S when I flashed it. That or the drive itself is finally kicking the bucket. luckily I had a Vad6038 laying around. spoofed the dvd key and loaded lt3+ and i was good to go. Hopefully it stays working. and not my xbox burning up dvd drives.
 
You must log in or register to reply here.