well guys, I have been away for a long while, but I had a unit laying around and finally finished installing a x3 into it it is a version 4. now if I remember correctly if I do not get a red x3 light on the panel, my d0 is not getting a good solder point.
I mean, right now with the chip enabled I get a blue light and it justs frags.
with chip off I get a blue light and its fine.
to be honest I can not remeber if I ever flashed it or not, it has been so long
I tried moving the dips to different positions, right now top 2 are on, like my other two x3 boxes.
tried the power and reset hold to get to back up no luck.
any ideas, here, or is it most likely the d0 connection?
by the way great to see team xecuter is back up and running strong
I mean, right now with the chip enabled I get a blue light and it justs frags.
with chip off I get a blue light and its fine.
to be honest I can not remeber if I ever flashed it or not, it has been so long
I tried moving the dips to different positions, right now top 2 are on, like my other two x3 boxes.
tried the power and reset hold to get to back up no luck.
any ideas, here, or is it most likely the d0 connection?
by the way great to see team xecuter is back up and running strong