a question

[CuddlyFriction]

i have read my nand and repaired it then created ecc file wrote the file and now my xbox wont boot any suggestions?

---------- Post added at 20:55 ---------- Previous post was at 20:55 ----------

oh yeah ive also went over my solders and resolderd a few

---------- Post added at 21:02 ---------- Previous post was at 20:55 ----------

the green light on the coolrunner keeps flashing on and off

 

[xblextreme]

write back the original nand and see if it boots

---------- Post added at 21:37 ---------- Previous post was at 21:35 ----------

the green light is supposed to flash about every 5 seconds, its tring to slow down the cpu thats what the green flash is.

---------- Post added at 21:39 ---------- Previous post was at 21:37 ----------

make sure you are using the correct comand for your mb when writing the original nand back very important.

---------- Post added at 21:44 ---------- Previous post was at 21:39 ----------

also once you have the original nand written back to the xbox put cr in program mode so its not tring to glitch your box or most likely you will get 2 rrod if you dont.

 

[oO Elite Oo]

Yes you need coolrunner programmed and wired to the correct points in order to boot to Xell then from there you gran your CPU key to create the final image to be written back to nand.

 

[DayvG]

What did you use to remap the bad blocks in your NAND? Some pix of your soldering woul be a good start as well.


Sent telepathically using Tapatalk

 

[Martin C]

Pics please - It's right there in the stickys.

 

[JayDee]

As above, pics (soldering and wire routing) and exactly what you did to repair the nand.

Only thing you can check before posting that is to switch the CR from slim->phat or vice versa and see if you get any luck.