GENERAL Advice before updating dash and to lt plus 2.0 .

[erickb05]

I have the following

Xbox360 Jasper Motherboard
with a Benq VAD 6038 (Spoofed as a liteon with lt 1.1)
dash pre 2.0.13146.

and i was preparing to update the latest dash and even returned to stock firmware on my old liteon ( which has the open tray error and in my opinion was not so good... compared to the benq)

but the problem as i saw in jungleflasher 188 it doesn't spoof the osig,, and then told that after the dash update spoofing is old news!!!!!

any help anyone!!!!!!

 

[BL4K3Y]

Just swap the laser out of the BenQ and into the open tray Lite-On. You cannot update your dashboard unless you use the drive that was originally in the console.

 

[erickb05]

i am planning on doing that with the open that should not be a problem, the thing is afterwards!! the open tray problem should be fix with a new laser?

 

[BL4K3Y]

It worked for me replacing the laser before, give it a shot.

 

[erickb05]

so officially theres no more spoofing drives?

 

[STEVEP1978]

i have swaped out the hole tray laser motor sliders from a benq to a liteon

 

[erickb05]

why the motors and all?