RGH After failed RGH got E79

[DayvG]

http://www.team-xecuter.com/forums/showthread.php?t=80190&highlight=rev

See the pic halfway down buddy

 

[cybermank1]

May be an idea as suggested to up a few pics.

I had a problem with my Xephyr. That was just a blank screen, green light on power button.

I reflashed several times and then had a brainwave to try the cap.

This instantly solved my problem.

 

[dirty9]

May be an idea as suggested to up a few pics.

I had a problem with my Xephyr. That was just a blank screen, green light on power button.

I reflashed several times and then had a brainwave to try the cap.

This instantly solved my problem.

i own only CR rev.A
i'm stupid not to try that Cap.
The photo of soldering... now it's only a bridge, should i post it? i'm trying to resize it because it's huge.

 

[Martin C]

Thread closed.

OP - PM me when you are ready to upload pictures of your work including soldering and wiring locations. I'm not having anyone's time wasted until we can see what you're actually doing.

 

[dirty9]

ok this is the pic. Only a bridge...
Now I want to return to original state.
My question: if i get B point on the back(alternative point), it should be soldered to the right end of qsb?
for reflash the nand only, only qsb are needed (no CR)?

thank you

p.s.: i think that is a breadcrumbs

 

[Martin C]

If you want to return to the original state, just remove the CR and flash the original NAND back.

 

[dirty9]

If you want to return to the original state, just remove the CR and flash the original NAND back.

ok thank you
but for reflash nand i need the B point anyway for the qsb (right end). that i found on the alternative point on back of the mobo.
instead if i would like to re-jtag the bridge that you see on the pic should be left or cut?

 

[Martin C]

Restore the console to stock state - if you've broken any traces they obviously need to be repaired.