after kamikaze - wont verify write

[dkopsieker]

I just kamikazee'd my slim, and everything seemed to go smoothly. I can lock and unlock my drive fine. Reading works good. But, when i try to write the lt+ 3.0 firmware, it doesnt verify. I tried 3 times, all the same result. The drive works fine in the console, and plays backups fine. Should i be concerned about getting banned because of this?

THanks!

 

[dkopsieker]

Also forgot to mention, since it stops at the "Write Verification Failed" part, it never goes to the "Restoring Sector" part..... but like i said, it seems to work fine. And no eject issues.

 

[paul.86]

every time i have seen Write Verification Failed it never worked you must be a lucky one if its locked i cannot see a ban coming your way but dont quote me

 

[dkopsieker]

yes, its locked and can be unlocked with alcohol... works every time. Only other weird thing, sometimes when i click the intro button to put it in vendor mode, and it asks me to cut power to drive for a cesond and turn it back on, sometimes it goes straight into vendor mode after i click yes. I dont need to turn power off. But the screen still comes up saying i have to cut power.

 

[sick360mods]

Ur lucky had this problem once wouldn't read back UPS

sent from HTC EVO sick360mods.com

 

[paul.86]

It's usual for the intro to work sometimes without turn off/on

Sent from my HTC Vision using Tapatalk

 

[JOD08]

yeah my 0401 drive will intro witout powering off/on thats a kamakazi wrights firmware fine thow no issues

 

[Ticallion]

I've had a few "Write verify" errors, seems 50/50 whether it will play backups or not, some do without any other problems, some don't and rule it down to Kamikaze gone bad.

 

[k0mpresd]

must be a 9504/0272 drive? only parts of there fw is hash checked.
0225, 0401, 1071 the whole fw is hash checked.

 

[kwazziee]

yes, its locked and can be unlocked with alcohol... works every time. Only other weird thing, sometimes when i click the intro button to put it in vendor mode, and it asks me to cut power to drive for a cesond and turn it back on, sometimes it goes straight into vendor mode after i click yes. I dont need to turn power off. But the screen still comes up saying i have to cut power.

This is true for me also. As the tutorial stated "most time it will kick in automatically".

@OP I did not us the Kamakazi method but instead TX PCB and had the same issue as you did. It played burned game without a problem however I got the writing process to complete. I was not able to outra and lock it(0x80). I was using a older version of JF. To all having this problem please make sure you are using the most UTD JF.