After new install of R-jtag on a felcon E79 help !

BL4K3Y

BL4K3Y

VIP Member
Jul 7, 2010
13,721
118
Colne, Lancashire (UK)
Look at this image and check that there is continuity between the coloured points (thanks to Martin C for the image).

Can you also confirm that the JTAG switches are switched right across to their correct positions?
 
Oggy

Oggy

Staff member
Troll Eating Dogs
Mar 1, 2010
3,346
128
Is the 330/470 switch actually in the middle? looks to the side a little
 
  • Like
Reactions: Magicherbz
Martin C

Martin C

VIP Member
Jan 10, 2004
35,981
0
Scotland, UK
www.team-xecuter.com
BL4K3Y said:
Look at this image and check that there is continuity between the coloured points (thanks to Martin C for the image).

Can you also confirm that the JTAG switches are switched right across to their correct positions?
Click to expand...
Did you do this? remember to set the off - 330/470 - on switch to 'on' in order to do this.
 
  • Like
Reactions: Magicherbz
M

Magicherbz

Full Member
Jun 21, 2012
48
0
Usa
well i played with it last night again , i was moving dip setting 7 to on and then just adding 1-5 to it , when i do dip setting 7 and 4 to no i will actually get a 79 e displayed on screen , and all the others i will get 3 reds flashing almost immediately , i then moved the from the bottom to r8c2 but sill had no luck .


My setting is now as follow

Falcon
jtag alt vt set to ON
jumper setting on 470 side
and switch 0-330/470-off is in the MIDDLE
cable removed from c7r112 and soldered to R8C2
 
M

Magicherbz

Full Member
Jun 21, 2012
48
0
Usa
I do have one question though, I flashed my Ben-Q a long time ago with jungle flash ,think i used 1.51 xecuter I never flashed it back to stock should that give me any problems ?
 
You must log in or register to reply here.