After new install of R-jtag on a felcon E79 help !
- Thread starter Magicherbz
- Start date
Make sure to test those points to the other side of the diodes on the qsb also for continuity. make sure the 2 way switch is on, or the points wont connect to the diodes at all. if you find your problem is the qsb itself just follow Blackaddr's Transitor jtag method, which everyone i have talked to who installed jtag back in the day prefered this method for aud_clamp.
well if every thing is getting continuity, then we go to the software side...... Did you make sure to hit AUD_CLAMP? and R-Jtag checkboxes when creating your nand. Did you try with non aud clamp jtag wiring and image?
I only did the aud clam wiring , never with out . I did select aud clamps text box For the install
Sent from my iPhone using Tapatalk
keil423
VIP Member
At this point I would also suggest that you flash back your retail NAND and remove the 5v from the rjtag chip. Verify that it still boots stock and also take note as to if the rol is flashing with the drive not connected.
As Gavin said you could also try creating a non aud clamp set up as well.
I'm wondering if the solder point near the end of the aud clamp qsb isn't getting a good connection or is damaged. You might try scraping the trace a little further back and test continuity.
As Gavin said you could also try creating a non aud clamp set up as well.
I'm wondering if the solder point near the end of the aud clamp qsb isn't getting a good connection or is damaged. You might try scraping the trace a little further back and test continuity.
Martin C
VIP Member
Have you 100% confirmed that the diodes on the QSB have continuity to DB1F1 and Q2N1 respectively?