ANSWERED after read nand good with no error console dead

[juanbrnt]

hey fellas here we go again lol. i read nand fine 2 dumps create ecc file fine write ecc file fine after all this now the xbox is dead no power ... i check my soldering and yes look good...b point look brigde, i fix it, finish messing up point b then i use the alt point and console still dead any sugestion?

 

[Hackerjac]

i have a sugestion, post some pic of your install

 

[juanbrnt]

i have a sugestion, post some pic of your install[/hold on i disconnect the nand x before i boot to xell

 

[juanbrnt]

here follow from the intalation the other are my neighbor he mess hes board http://s1191.photobucket.com/albums/z472/juanbrn/

 

[ll4sheezy]

Please post pics of your install.


Sent from my iPad using Tapatalk HD

 

[juanbrnt]

Please post pics of your install.


Sent from my iPad using Tapatalk HD

here follow from the intalation the other are my neighbor he mess hes board http://s1191.photobucket.com/albums/z472/juanbrn/

---------- Post added at 11:31 ---------- Previous post was at 11:31 ----------

i have a sugestion, post some pic of your install

here follow from the intalation the other are my neighbor he mess hes board http://s1191.photobucket.com/albums/z472/juanbrn/

 

[seanr28]

If no power and you are sure that the ecc file created was correct, looking t your soldering, I would say the following.

Too much cablestripped (keep this to mininum), but I would suggest that you have probably over heated the resister next the the STDNB_CLK point (orange cable). I would suggest mearsing the resistance accros the resister next to it and post your results....