Folks,
Need help here. I just completed X3 install (v1.6 PCB)
I can switch between Enable/Disable/Boot from 256k backup but there is no Flash BIOS screen. (MS dash boots w/o any problems)
What switch settings should I use? (off off off off off has no effect)
Big thanks!
P.S. btw, could someone tell me what's the small wheel on X3 is for?
Need help here. I just completed X3 install (v1.6 PCB)
I can switch between Enable/Disable/Boot from 256k backup but there is no Flash BIOS screen. (MS dash boots w/o any problems)
What switch settings should I use? (off off off off off has no effect)
Big thanks!
P.S. btw, could someone tell me what's the small wheel on X3 is for?