All Things Point To Good

[Andybaines]

Sorry but I couldnt find this problem, with all the various errors searching isnt easy, lol.

I had installed an X3 a while back into my XBox, recently the lil logo on the front doesnt change to blue, only red on boot, Ive got the lil switches on the front set as always so I tried the power & eject buttons but it didnt go purple so Im guessing its a connection, to my surprise my chip still have 2 blue LEDs both turning on upon booting, anyone got any advice on how to proceed..? Im kinda stumped, lol.

Thankyou very much

Andy

PS. XBox is booting fine, no FRAG or anything.

 

[Andybaines]

Huh, even though it looked good it was the D0, I took it off, re soldered it and its booting fine again, weird.

I wont be surprised if this thread is deleted.

 

[tonylott]

Sorted

Huh, even though it looked good it was the D0, I took it off, re soldered it and its booting fine again, weird.

I wont be surprised if this thread is deleted.

Well done mate. I don't think this post will be deleted and many should learn from it.. Just because a solder joint looks good doesn't mean it is good.

Bet you felt ace when the little darlin powered up.... Top job