Almost there... I think!?

[chris.hoch]

Ok started to install at 1pm and by 9pm I had managed to get the switch bank to light up, both 5v and 3.3v LED's are lit up.

If i try to enable the X3 then it seems to FRAG, if I run it disabled it is ok. So when I get back to work i am going to check all the solder points on the LPC, does anybody have any quick tips in to hunting for the FRAG'ing issue?

regards

chris

 

[metalgear]

i HAD THE SAME PROBLEM I GOTTA V1.6 BOX MY PROBLEM WAS THE SOLDER BETWEEN POINTS 13 AND 14 AFTER I RE-SOLDERED THAT I WAS GOOD TO GO,
THERE'S A STICKY ON THIS SUBJECT

 

[Scudworm]

Best way is to touch up all your points. And read other people's threads. Because you might be missing something.

 

[jsun]

double check the 13 and 14 points (along with all others) also look for crimped wires that may have been crushed when you but the mobo back in the case the slightest damage to your d0 (grey) or hd (red) lan(green) could cause problems. Good luck!