Alt 5.0v on v1.0 Xbox

[Vol4Ever]

My pin 6 isn't getting 5.0v. I found the diagram for the alt 5.0v connection on the 1.6 Xbox (http://www.teamxecuter.com/x3/tutorials/16/x3_alt5v.jpg). Can anyone give me an alternate 5.0v point for v1.0 mobo?

Will it work if I just find a point that reads 5.0v and solder in a jumper, or does this pin voltage change depending on if you are trying to boot the the chip BIOS or the MS BIOS?

 

[Floyd85]

Umm you dont need an alt 5v for a 1.0
check the install closely and figure it out because you dont need the alt 5v you need the right 5v from the lpc port.
Im hoping that you used the wire install on your 1.0

 

[Vol4Ever]

I tried the pinheader 1st. Major complications (VERY long story). Went back with wire method. LPC pretty mangled so I'm using alternate mobo points (found & soldered under electronics microscope). Still need alternate 5.0v point. Tracings got damaged and I'm having trouble following where pin 6 is supposed to go.