Alternate 3v3 when using Pin Headers ?

[gargoyle67]

Just installed some pin headers for nand reading\writing, The only problem is that the glitch chip needs one of them for power. So the question is were can I get 3v3 from instead of the pin header ?
Thank you.

 

[Martin C]

solder a wire to the underside of the board, where the 3.3v connection is.

 

[gargoyle67]

Yeah I thought about that but I was hoping for a closer route, Guess I'll prob end up going that route though, Thanks Martin.

 

[Martin C]

There probably is, but without my meter and a board in front of me I couldn't tell you.

 

[gargoyle67]

No worries Martin I'll dig out mine and have a look, Cheers bud.

 

[gargoyle67]

Got a good signal from R2B16 pad although I think it may be a bit small for the 3v3 gage wire.

 

[Martin C]

You can use smaller gauge wire if you need to. Shouldn't cause any issues.

 

[gargoyle67]

Thanks Martin, Ended up going under the pin with thicker gage wire for safety sake.