alternate d0 point

[Toopty]

I fumbled up my do point on a v 1.0 and have repaired the board, but now i need an alternate d0 point, can anyone help?

 

[BLUEku]

there is like 4 other places that you can use. 2 on the bottom of the board at the start and end of the trace, and the one on top trace and then the 25 pin on the bios

 

[burgan]

BlueKU

If you get a chance and could point out the points on the top i would appreciat eit. i found one on the chip on top but couldn't find another.

thanks,

Jeff

 

[BLUEku]

I will get around to it when I can, Right now I am working on turning a Laptop into a mobile xbox But when i get a chance I will post it.

 

[Bytecode]

Here is an alt d0 on the topside.

http://66.111.59.177/pictures/1.6/1.6-top-pro_install-.jpg

 

[overclocking]

just to help with the do point... my do point was screwed up on my x3 install and what i did was follow the do wire tracer to a little transistor looking thing its about a mm away from the do point. connect the side of the transistor to your do point with a tiny bit of solder and it will work. i had a heck of a time figureing it out as it looked like my do was fine but aparently it wasnt until i did this. good luck once i did this my x3 came to life.

 

[douceur]

Complete noob

I am really really new to modding Xbox 360s and I am in desperate need of help. All I pretty much know is how to take one apart, that I'm pretty sure it's a BenQ model because of the white wires. I don't really know anything else about it or what kind of firmwares I need to have or what equipment. I've seen tutorials that just used a SATA cable and some kind of PCI card. I really need some help lol

 

[douceur]

Re: Complete noob

Just learned that it is Liteon revision 74850C

 

[GodZilla]

Re: Complete noob

Read the Jungleflasher tutorial!

You can find it in the downloads section

 

[yaq15]

Re: Complete noob

first of all u need a ck3pro to extract the key