JTAG Alternate jumper connection

[green_fingers]

Hi Peepz, I have ordered my Nand-X and it should be arriving 2moz
Thing is i tried to jtag using the diodes then realised i dont have a printer port and i was using crap wire
I have disconnected the jtag wires and it seems j2d2.7 is damaged. Dont know if its possible but it seems the copper ring has fell out. I was just wondering can i still use qsb jtag from nand x or should i use diode method (got Kynar Wire now) and use a different point for jumper. Which other point could i use.
Thanks in advance
EDIT: Also i would like to use pin header connection for nand. Do i have to solder the bits into the MB

 

[manwithoutname]

If you have damaged the points to that extend then you won't be able to use either the QSB's or pin headers. Instead you will need to solder the NAND-X wires directly onto the motherboard using either the alternate points or directly to the traces.

 

[green_fingers]

Hi manwithoutaname, thanks for the quick reply, sorry if i didnt explain well. All my nand points are fine, it is just the 1 point on the jtag. I read somewhere that it is just for the jumper (Usually its j2d2.4 to j2d2.7 i think) so i can just reroute (j2d2.4 to j1f1.5) but wanted to check with all the geniuses in this forum. I hope this makes sense

EDIT: Thanks for the link manwithoutaname, exactly what i needed

 

[RedFarmer]

I think it should also be possible for you to stick the jumper cable through the hole on the damaged point and solder it from the bottom.